C
L
L
C
12 1/2"
6 1/4"
6 1/4"
4"
MINIMUM
1/2"
MINIMUM CLEAR *
22" CLEARENCE FOR
COVER REMOVAL
3" RECOMMENDED FOR
OIL SUPPLY LINE CLEARENCE
15"
7 1/2"
SK9892
Remove the four Phillip’s head screws from the
existing square plate on the front of the burner.
Discard the old square front plate.
Attach the new front plate using the four Phillip’s
head screw removed in Step 3.
Reattach the air tube assembly using the four air
tube mounting screws. Reinstall the nozzle line
electrode assembly, secure with the spline nut
and reattach the copper oil line. Before placing
the burner in service check for leaks, and make
sure the Z dimension is correct per the set-up
instructions in the Beckett Installation Manual
supplied with your burner.
To install the cover, place the guide pins through
the triangular holes in the cover mounting plate
and snap the latches over the edge of the
mounting plate.
To latch the bottom of the cover, slightly pull on
3.
4.
5.
6.
7.
INSTALLATION
INSTALLATION
INFORMATION
INFORMATION
AF/AFG/CF375/NX BURNER COVER
AF/AFG/CF375/NX BURNER COVER
(WITH ONE PIECE MOUNTING PLATE)
(WITH ONE PIECE MOUNTING PLATE)
PART NO. 5207302U & 5207303U
PART NO. 5207302U & 5207303U
Figure 1
Review the existing oil lines. They must be installed so
that they will pass out through the slot in the bottom of
the cover. If they do not, they must be removed and rein-
stalled later. (See Figure 3.)
.
Preparing to Install the Cover
Remove the burner from the appliance. Loosen
the two front igniter hold down screws and swing
the igniter back on its hinge. Remove the copper
oil line from the escutcheon plate by loosening
the spline nut and removing the line. Pull the
nozzle line electrode assembly out of the burner
housing and set to one side.
Remove the four air tube mounting screws and
detach the air tube assembly. Retain the screws
and air tube assembly for reinstallation. (Refer to
Figure 2.)
1.
2.
Please read and understand the manual supplied with this
equipment. This equipment must be installed, adjusted and put
into operation only by a qualifi ed individual or service agency
that is:
Licensed or certifi ed to install and provide technical ser-
vice to oil heating systems.
Experienced with all applicable codes, standards and
ordinances.
Responsible for the correct installation and commission of
this equipment.
Skilled in the adjustment of oil burners using combustion
test instruments.
The installation must strictly comply with all applicable codes,
authorities having jurisdiction and the latest revision of the Na-
tional Fire Protection Association Standard for the installation
of Oil-burning Equipment, NFPA 31 (or CSA B139 and B140 in
Canada).
Regulation by these authorities take precedence over the gen-
eral instructions provided in this installation manual.
1.
2.
3.
4.
Incorrect installation, adjustment, and
use of this burner could result in severe
personal injury, death, or substantial
property damage from fi re, carbon mon-
oxide poisoning, soot or explosion.
Professional Service
Required
WARNING
!
Disconnect electrical power before installing or servicing the
burner.
Electrical shock can cause severe personal
injury or death.
Electrical Shock Hazard
WARNING
!
Notice Special Requirements
Figure 1 shows the required clearances around the
burner for a successful and easy cover installation.
System Installation Requirements
