9
• The tip of the Tie-Wire should be straightened out to allow it to pass through the wire feeding
mechanism.
When mounting the Tie-Wire, the wire may become jammed inside the machine if the wire tip is bent.
If the window is dirty and the pipe position can’t be confirmed
Open the window and wipe off the dirt on the inside of the window with a soft cloth, etc. Close the window again after
cleaning to ensure that foreign objects will not be able to enter the machine.
•
Release the release stopper, and confirm that the release lever has returned to its original position and that
the feeding gears are clamping the Tie-Wire. This completes the Tie-Wire mounting operation.
•
Remove the tape from the tie-wire completely.
•
Remove slack from wire spool.
•
Make sure the Tie-Wire does not get caught behind the wire spool .This could lead to jamming.
•
When turning the main switch to ON, do not place your fingers near the binding part and rotating part of the
tool's tip.
•
Do not switch the main switch ON and OFF in rapid succession, since this operation will cause machine
the tool to prematurely breakdown.
• Do not touch the Tie-Wire during the tying work (while the machine is operating)
Mount the battery pack on the tool's main body until a click is heard. Turn the main switch on.
Unlock the trigger before using the tool.
2. How to remove the Tie-Wire
• Be sure to turn the main switch OFF, lock the Trigger, and remove the battery pack.
Press the release lever, and confirm that the release lever is caught in the release stopper.
Remove the Tie-Wire from the wire guide.
Slide the Reel stopper to release the reel holder and remove the Tie-Wire.
Mount the new Tie-Wire. (Refer to the Tie-Wire mounting method explanation.)
When the Tie-Wire runs out of binding wire
There should be around 12" (300 mm) of the Tie-Wire left at end of the spool. This should be discharged with the old
spool and be replaced with a new one.
3. Tension adjustment
Be sure to turn the Main switch OFF, to lock the Trigger and detach the Battery pack.
This dial allows you to adjust wire tension torque slightly.
To increase the tension, turn it in the counter clockwise.
To decrease the tension, turn it in the clockwise.
Insert the charged battery pack into the tool until a click is heard.
4. When setting the main switch to ON, absolutely do not bring your hand close to the binding part or
rotating part of the tip of the tool.
Set the Trigger Lock to UNLOCK and turn on the main switch.
Test the tool again to check the tie strength.
If the tie strength is not appropriate, repeat procedures
~
5. For proper tightness
Set the tension dial
Apply the tool over the pipe and rebar or wire mesh. Place the top side of the pipe at the top of the arm part. Tie
should not dimple or dent pipe. If pipe is dimple or kinked, repair the pipe according to the pipe manufactures
recommendations.
During tool operation
• Do not move the tool during tying operation until the tool stops tying automatically.
6. MAINTENANCE
Inspect tool prior to every use
In order to maintain the performance of the tool, periodically clean up and inspect the tool.
Do not lubricate the equipment
