2
OPERATING & MAINTENANCE MANUAL INDEX
1.
SAFETY INSTRUCTIONS
2.
SAFETY FEATURES
3.
SPECIFICATIONS AND TECHNICAL DATA
4.
BATTERY INSTRUCTIONS
5.
OPERATING INSTRUCTIONS
6.
MAINTENANCE
7.
STORAGE
8.
TROUBLE SHOOTING & REPAIRS
9. WARRANTY
1. SAFETY INSTRUCTIONS
READ THE FOLLOWING SAFETY INSTRUCTIONS TO AVOID SEVERE PERSONAL INJURY OR PROPERTY
DAMAGE.
PRECAUTIONS ON USING THE TOOL
This tool in intended for use for tying re-bar, PEX and/or PEX-AL PEX pipe to re-bar or wire mesh. Using the tool
for other applications or in ways not specified in the manual may lead to serious injuries. Strictly observe the
information written in this manual. This tool is intended for use by professional contractors only.
1. WEAR SAFETY GLASSES OR GOGGLES
The use of proper eye protection is worn when the tool is being used. Eye protection equipment must conform to
the requirements of the American National Standards Institute, ANSI Z87.1 (Council Directive 89/686/EEC of 21
DEC. 1989) and it must provide frontal and side protection.
NOTE: Non-side-shielded glasses or goggles and face shields alone do not provide adequate protection.
2. EAR PROTECTION MAY BE REQUIRED IN SOME ENVIRONMENTS
Because working conditions may include exposure to high noise levels that could lead to hearing damage, the
user should make sure that necessary hearing protection is provided and used by the operator and others in the
work area.
3. DO NOT ALLOW CHILDREN NEAR THE TOOL
Allow no bystanders, especially children, near the tool during its operation.
4. DO NOT USE THE TOOL OR CHARGER IN ANY WET CONDITION SUCH AS RAIN, SPLASHING WATER
OR IN A DAMP PLACE
Using the tool in these or similar conditions will increase the risk of electric shock, dangerous malfunction, and/or
overheating and will void warranty.
5. INSPECT THE TOOL BEFORE MOUNTING THE BATTERY PACK
Examine the screws to make sure they are securely tightened. Incomplete tightening may result in an accident or
breakage. If a screw is loose, retighten it completely.
Inspect parts for damage. Parts will wear over periods of use. If a part must be replaced or repaired, purchase
the replacement part at an authorized distributor. Use only genuine authorized replacement parts.
6.
BE SURE TO SET THE MAIN SWITCH TO THE OFF POSITION AND LOCK THE TRIGGER WHEN
CHANGING THE BATTERY PACK AND WHEN REPLACING OR ADJUSTING THE TIE WIRE, WHEN
ABNORMALITIES OCCUR, AND WHEN THE EQUIPMENT IS NOT BEING USED
Leaving the equipment switched on in these situations may cause breakdowns or damage.
7.
KEEP YOUR HANDS AND BODY PARTS CLEAR OF THE FEEDER ARM AND CURL GUIDE AT ALL TIMES
Failure to do so may result in serious injury.
