PEUGEOT Satelis, Service Manual

Page: 31 / 83

31
- Check that the clutch housing shows no signs of wear or damage.
- Measure the clutch housing I.D.
Standard value: 160.2 mm
Max value: 160.5 mm
N.B. : Check that the measured eccentricity is max 0.2 mm
Driven pulley assembly
- Remove the driven pulley assembly and relevant belt.
Clutch disassembly
- Remove the clutch and driven pulley by means of the specific tool;
- Prepare the tool with the pins screwed in the «
E » position on the internal side;
- Assemble the driven pulley assembly on the tool and insert the pins in the ventilation holes;
- Bring the rear stop screw in contact with the fixed driven pulley, as shown in the figure.
Warning
- Put the tool in a vice firmly. Do not overtighten the rear screw to avoid buckling the tool.
Remove the fixing ring nut with the specific spanner of 55 mm.
- Unloose the tool screw and dismount the driven pulley, clutch, spring with sheath assembly
Specific tools:
Driven pulley spring compressor 020444Y
55 mm spanner 020444Y009
Ring 020444Y010