PEUGEOT Satelis, Service Manual

Page: 25 / 83

25
Hub oil capacity: ~ 250 cc
Recommended oil:
TUTELA ZC 90
------------------------------------------------------------------------------------------------------------------------------------------------------------
Engine cooling Adding coolant and bleeding air from the system.
The level of the fluid must be checked every 6,000 km when the engine is cold.
Follow these steps:
- Put the vehicle on the central stand on level ground.
- Remove the expansion tank cap and top up if the coolant is below or near the MIN level in the expansion
tank. The level of the fluid should always be between the
MIN and MAX marks.
- To have an indication of the coolant level, refer to the groove in the plastic strip that can be seen through
the coolant filler hole. The upper and lower parts of the groove correspond to the MAX and MIN levels
respectively.
- The coolant consists of a 50 percent mixture of demineralized water and antifreeze solution with a base of
ethylene glycol and corrosion inhibitors. Total coolant capacity:
~ 1.8 lt
- To check the presence of air in the circuit follow the procedure described in Chapter 11 - Cooling.
- Switch off the engine and allow it to cool down. After a few minutes, remove the expansion tank cap and
check the level of the fluid.
- If necessary, top up by pouring fresh coolant into the expansion tank up to the correct level.
Warning
- To prevent the coolant from leaking out of the expansion tank during use, be sure to never exceed the
MAX level when refilling.