PEUGEOT PARTNER 2016, Handbook, Page: 65 / 260

63
Steering mounted controls
EASE OF US
E and
COMFORT
4
Partner-2-VU_en_Chap04_Ergonomie_ed02-2016
Changing the
programmed
speed Switching the system off
Operating fault
Cancelling the programmed
speed setting
When the vehicle becomes stationary,
after switching off the ignition, the
system no longer memorises a speed.
There are two methods of memorising
a speed
higher than the previous one:
- Place the dial in position 0 or
switch off the ignition to switch
everything off.
Good practice
Without using the accelerator
- Press the SET + button.
A brief press increases the speed by 1 mph (km/h).
A maintained press increases the speed
in steps of 5 mph (km/h).
Using the accelerator
- Exceed the memorised speed until
the speed required is reached,
- Press the SET + or SET - button.
To memorise a speed lower than the previous one:
- Press the SET - button.
A brief press decreases the speed by 1 mph (km/h).
A maintained press decreases the speed in steps of
5 mph (km/h).
The programmed speed setting is
cleared and replaced by three dashes.
Contact a PEUGEOT dealer or a
qualified workshop to have the system
checked.
When changing the programmed
speed setting by means of a
maintained press, pay attention as
the speed can increase or decrease
rapidly.
Do not use the cruise control on
slippery roads or in heavy traffic.
In the event of a steep slope, the cruise
control cannot prevent the vehicle from
exceeding the programmed speed
setting.
In any event, the cruise control cannot
replace the need to observe the speed
limits and the need for vigilance on the
part of the driver.
It is advisable to keep your feet near
the pedals.
To avoid any jamming under the
pedals:
- ensure that the mat and its fixings
on the floor are positioned correctly,
- never place one mat on top of
another.