PEUGEOT Energyscroll 400, Operating Instructions Manual

Page: 22 / 30

PIN-END BLADES
1. Lift up the quick release tension lever to release the tension of the blade. ( Fig. 5 )
2. Make sure the slots on the upper and lower blade holders are slightly wider than the thickness of the blade.
3. Hook the blade pin in the pin recess in the lower blade holder. ( Fig. 7 )
4. Press the upper arm down and hook the other end of the blade pin in the pin recess in the upper blade holder. ( Fig. 7 )
5. Make sure the pins are properly located in the pin recesses.
6. Lower the quick release tension lever and turn the lever clockwise for proper tension of the blade. ( Fig. 5 )
NOTE : If the lever is difficult when lowered, turn it anticlockwise to loosen the blade tension.
Aligning the bevel indication (Fig.4)
1. Loosen the table lock handle and adjust the table until it is approximately at a right angle to the blade.
2. Use a small square to set the table at 90° to the blade.
3. When the space between the square and the blade is minimal, tighten the table lock handle.
NOTE : Two set screws are provided on tilt - bracket for accurate adjustments of 90° and 45° cutting.
4. Loosen the screw holding the bevel scale pointer and adjust pointer to 0°. Tighten the screw.
NOTE : We highly recommend that you bolt this scroll saw securely to a workbench to gain the maximum stability of your
machine and to prevent noise and vibration.
1. Use the scroll saw as a template to mark the bench through the mounting holes in the casting. And drill the bench with a
Ø10mm drill bit.
2. Bolt the scroll saw on the bench with bolts, washes, and nuts. Note that these fasteners are not supplied with the machine.
Placing a soft foam pad or carpet between the saw and the workbench is highly recommended to further reduce noise and
vibration.
Check that the power supply and plug used is in accordance with your scroll saw. Have a look at the rating plate of the motor or
the rating on the scroll saw. Any changes should always be carried out by a qualified electrician.
If not being properly earthed this machine can cause an electrical shock. Be sure that the power supply outlet is earthed. If there
is any doubt, please have it checked by a qualified electrician.
The use of any extension cord will cause some loss of power. To keep this to a minimum and to prevent overheating and motor
burn-out, ask advice from a qualified electrician to determine the minimum wire size of the extension lead.
The extension cord should be equipped with an earthed type plug that fits the power supply outlet at one end, and with an
earthed type socket that fits the plug of this machine at the other end.
Read and understand the following items about your scroll saw before attempting to use the machine
SETTING THE MACHINE
MONTING THE MACHINE ON A BENCH
CONNECTING TO POWER SUPPLY
ATTENTION : This machine must be earthed.
WARNING
:
Avoid contact with the terminals on the plug when installing (removing) the plug to (from) the power
supply outlet. Contact will cause a severe electrical shock.
OPERATING THE TOOL