PEUGEOT Energyscroll 400, Operating Instructions Manual

Page: 24 / 30

4
NOTE : Scroll saw blades generally stay sharp for 1/2 to 2 hours of cutting.
Plain-end blades Pin-end blades
General maintenance
General
An occasional coat of paste wax on the work table will allow the wood being cut to glide smoothly across the work surface.
Arm Bearings
Lubricate the arm bearings after every 50 hours of use.
1. Turn the scroll saw on its side. ( Fig. 8 )
2. Squirt a generous amount of SAE 20 oil around the shaft end and bronze bearing.
3. Let the oil soak in overnight in this position.
4. Next day repeat the above procedures for the opposite side of the saw.
Art. N° TPI Tooth
style
Application
96100 32 Skip 3-6 mm brass, soft metal
96101 25 Skip 2-6 mm wood veneer, plastic hard
rubber, pearl, etc.
96102 20 Skip 2-13 mm wood veneer, wood, bone,
fibre, ivory, plastic, etc..
96103 17 Skip 2-19 mm hard/soft wood, bone, horn,
plastic, etc.
96104 15 Skip 25-38 mm hard/soft wood, bone,
paper, felt, plastic, etc.
96105 13 Skip 25-50 mm hard/soft wood, bone,
paper, felt, plastic, etc.
96106 12 Reverse
skip
6-13 mm hard/soft wood, plywood,
etc.
96107 12 Reverse
skip
6-25 mm hard/soft wood, plywood,
etc.
96108 10 Reverse
skip
25 mm and more, hard/soft wood,
plywood, etc.
96114 8 Reverse
skip
38 mm and more, hard/soft wood,
plywood, etc.
Art. N° TPI Tooth
style
Application
96113 10 Regular 25-50 mm, hard/soft wood, plastic,
etc.
96110 15 Regular 25-38 mm wallboard, pressed wood,
wood, felt, paper, bone, lead, etc.
96111 18 Skip 2-13 mm wood, plastic, etc.
96112 25 Skip 2-13 mm wood, plastic, etc.
MAINTENANCE
WARNING ! For your own safety, turn the switch off and remove the plug from the power source outlet before
maintaining or lubricating your scroll saw.
OPTIONAL ACCESSORIES