PEUGEOT ENERGYSaw-254STB, Using Manual, Page: 13 / 21

3
4
For long workpieces, your miter saw has rails (1) at the bottom of table, right and left. These grooves are extensible
right and left of the table. To unlock, unscrew the screws (2 and 3) located behind the rails. Change their position and
tighten the screw.
90 ° cutting
• Place the machine head in the upper position.
• Place the piece of wood to be cut against the rails and on the turntable.
• Fix the piece of wood to cut with the press on the base to prevent it from moving during cutting.
• Press both the ON / OFF switch on the blade guard release lever and push the safety switch to start the engine.
• After cutting, raise the head of the machine upper, rest position and release the on/Off switch.
bevel cutting
Your miter saw has a control system for precise bevel (1) with a locking adjustment to cut diagonally to the left or
right bevel cut.
To fine-tune the bevel cutting, use the mark (3).
Bevel right: free head by pushing the trigger (10) located at the front of the table upwardly. Free right bevel lowering
the stopper (2). Orient the head and adjust the angle the desired cut.
combined cutting (bevel and angle)
Your miter saw can also perform miter cuts on the left of 0 ° - 45 ° relative to the working surface and at the same
time from 0 ° - 45 ° relative to the stop rail.
• Place the machine head in the upper position.
• Loosen the rotary table by loosening the locking handle and lifting the trigger underneath the table in front.
• Set the rotary table to the desired angle and lock the handle.
• Lift the locking lever (10) and tilt the machine head to the left on the extent desired angle using the handle.
• Lower the locking lever (10). In this position, if the press impedes radial displacement, it must be put on the oppo-
site side to the inclination.
adjusting the depth cut
Normal position, the depth stop (11) allows you to make a complete cut through the wood. When the saw head is
raised, you can adjust the depth stop (11) by pulling to the right. The adjusting screw of the cutting depth will come
into contact with the abutment e once the head is lowered.
The depth of descent of the blade can be adjusted so that the saw can make the grooving.
The maximum cutting depth should be adjusted so that the blade is not in contact with the base of the saw, the
blade can damage the saw base. To adjust the depth of cut, follow these steps:
Raise the saw head to its highest position.
Loosen the screw nut (10).
Screw or unscrew the screw (10) for adjusting the depth of cut by the desired cutting depth.
Tighten the lock nut of the screw (10).
NOTE: If the adjusting screw of the cutting depth (10) is set too high, the blade will not cut entirely through the
piece. Always make a test cut after changing the cutting depth of the saw.
Miter cutting
The table has a built in table ruler with various pre selected angles: 0 °, 15 °, 22.5 °, 30 ° and 45 ° to the left and to the
right. When you turn the table (9), it will automatically stop at the next measurement angle.
To turn the table, make sure that the rotation handle of the table is loose, then move the table to the desired angle
by raising the trigger under the handle rotation.
Then tighten the front handle of the table to ensure the stability of the angle adjustment.
setting the table guides
using the sliding mitre saw
en
132049-EnergySaw-254STB-Manual.indd 13 9/09/15 17:10:36