6
7
6
7
iMPortant:
Do not overtighten belt tension
because it does not require excessive tension
to function properly. Excessive tension will
reduce motor and belt life.
10. After correct tension is obtained, tighten lock
nut (5), and position sanding table (3) in the
horizontal position by loosening the two bolts
(4). Retighten the bolts (4).
11. Replace pulley cover, sanding disc cover
by following above instructions in reverse.
Adjust sanding cover if it touches the sanding
disc.
12. Replace sanding disc on shaft, making sure
the set screw is aligned with the flat surface
on shaft.
After sanding wood or non-metallic material,
always clean area of sawdust before grinding
or sharpening metal workpieces. Sparks could
ignite and cause a fire.
lUbrication
Ball bearings are grease packed at the factory
and require no further lubrication. Use a spray
lubricant to ensure smooth operation on all
moving table parts.
Summary of Contents for ENERGYSand-100
Page 8: ...8 8 ...
Page 24: ...24 24 Sommaire GB P 1 7 D P 9 15 F P 17 23 The original instruction manual is in English ...
Page 29: ...29 29 Fig 27 Fig 25 Fig 26 4 3 9 4 8 7 6 5 2 3 1 2 1 Fig 28 Fig 29 ...
Page 30: ...GB Combiné ponceur bandes et disque ENERGYSand 100 MANUEL D UTILISATION ...
