PREPARING REMOTE TRANSMITTER FOR YOUR FIRST USE:
Make sure that Remote Transmitter is charged before proceeding to the training:
1. The charging port is located on the rear side of remote. Carefully open the rubber
cover and connect the charger.
2. Red LED light will indicate that remote is charging.
3. LED indicator will turn green when remote is fully charged. It takes about 2 hours to
a full charge.
4. Put the rubber cover back over the charging port.
REMOTE TRANSMITTER OPERATION
1. Rotate the knob clockwise with your thumb to turn it on. The knob also allows you to
quickly switch between different stimulation levels of Shock and Vibration.
2. If you have 2 collars, you can select which collar is being controlled (1 or 2) by sliding
the Channel switch.
3. Press the Vibration Button to deliver Vibration Stimulation to your dog.
4. Press the Continuous/Convulsive Shock Button to deliver shock to your dog.
5. Press the Tone/Beep Button to deliver beeping tone to your dog.
6. The Remote Transmitter will enter a Standby Mode if not operated for 1 minute.
Simply press any button to bring it back.
PREPARING RECEIVER COLLAR FOR YOUR FIRST USE:
Make sure that Receiver Collar is charged before proceeding to the training:
1. Carefully open the rubber cover over the charging port and connect the charger.
2. Red LED light will indicate that receiver is charging. It takes about 3 hours to fully
charge it. Make sure to unplug the collar after 3 hours to avoid battery damage.
3. Put the rubber cover back over the charging port to ensure collar is fully waterproof.
4. Press the Power Button to turn it on. The red LED will start flashing every 4-5 sec-
onds.
5. When Receiver is charged and turned on, it always stands in the Sleep/Standby Mode
waiting for any command (e.g. Shock, Vibration or Beep) to activate it.