Petsafe Stay & Play PIF00-13663, Product Manual

Page: 10 / 20

1-800-732-2677 10
Set the Static Correction Level
Read all steps before attempting to set the static correction level.
1. Press the mode button and release (
3B
) when the receiver indicator light illuminates red (
3C
).
2. The receiver indicator light will emit a series of red flashes representing the static correction level.
3. Increase the static correction level by pressing and releasing the mode button within 5 seconds of the previous series of flashes.
The static correction levels increase in strength from 1 to 6. Pushing the correction level button while the receiver collar is on Level 6 will cause
the receiver collar to revert to Level 1. Refer to the function and response table to choose the static correction level that best fits your pet.
Function and Response Table
Indicator Light Response Static Correction Level Receiver Collar Function
1 Red Flash 1 No Static Correction, Tone Only
2 Red Flashes 2 Low Static Correction
3 Red Flashes 3 Medium-Low Static Correction
4 Red Flashes 4 Medium Static Correction
5 Red Flashes 5 Medium-High Static Correction
6 Red Flashes 6 High Static Correction
Over Correction Protection
If your pet enters the boundary zone or continues anywhere beyond the pet area, this feature limits the static correction duration to 15 seconds.
While the system locks out further static correction, the green light will remain on for 10 seconds.
In the unlikely event that your pet leaves the pet area, he will not receive a static correction upon return to the pet area.
Step 4: Adjust the Pet Area to Desired Size
Make sure the entire pet area lies within your property boundaries (
4A
). Always start determining the boundary zone at the shortest distance
from transmitter. Place the boundary switch on “–” if the boundary zone will be less than 45 feet from the transmitter.
Note
: If your next-door neighbor has a containment system, see Troubleshooting section page 16.
Test Light Instructions
1. Make sure the receiver collar battery is properly charged.
2. Set the correction level to 2 or above.
3. Hold the test light contacts to the contact points (
4B
).
4. Walk toward the boundary zone holding the receiver collar about waist high until the test light flashes (
4C
).
Save test light for future testing.
To maximize your pet area, make sure the boundary switch is on “+” and the boundary control dial is set to “8”. Plug power adaptor into power
jack and standard 120 volt outlet. Turn the transmitter on.