Petsafe PTY00-16416, Product Manual

Page: 2 / 28

2
petsafe.com
EN
ES
FR
IT
NL
DE
Hereinafter Radio Systems Corporation, Radio Systems PetSafe Europe Ltd., Radio Systems Australia Pty Ltd. and any other
affiliate or Brand of Radio Systems Corporation may be referred to collectively as “We” or “Us”.
IMPORTANT SAFETY INFORMATION
Explanation of attention words and symbols used in this guide
This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety
messages that follow this symbol to avoid possible injury or death.
CAUTION
, used with the safety alert symbol, indicates a hazardous situation which, if not avoided, could
result in minor or moderate injury.
CAUTION
, used without the safety alert symbol, indicates a hazardous situation which, if not avoided,
could result in harm to your pet.
NOTICE , is used to address safe use practices not related to personal injury.
Keep away from children.
• Not intended as a toy for children.
• Do not allow small children to use this product to play with your pet without adult supervision.
• Do not use this product until you have read the entire Product Manual.
• Do not use this product on an elevated surface such as a table or counter. Use on the floor only.
• This product should only be used in accordance with the instructions in the user guide.
• Adult supervision is required around pets.
• Inspect this product periodically for damage and discard product immediately if it appears worn
or broken.
• Do not mix old and new batteries.
• Do not mix standard, alkaline or rechargeable batteries.
• Do not use rechargeable batteries.
• Exhausted batteries should be removed immediately. Do not dispose of batteries with household
waste.
These instructions must be retained and passed on with ownership.
Toy assembly
No assembly is required. To use, simply install batteries and follow the Operating instructions. Do not place the toy on any
surface other than a flat, level floor.
Battery installation
1. Unscrew the two different coloured halves of Toy A by hand
and gently pull to remove the battery and sound cylinder (
A
).
2. Firmly pull to remove the retaining cap from the end of the
battery and sound cylinder (
B
).
3. Once the retaining cap is removed, insert 3 AAA batteries
(not included) into the slots in the side of the cylinder (
C
).
4. Locate the notch in the retaining cap and align it with the
corresponding groove in the battery and sound cylinder. Slide
into place.
A
B C