Operating Guide
Prepare the Remote Transmitter
To Insert and Remove the Battery
1. Hold the Remote Transmitter face down and
pull the battery door open (
A
).
2. Insert the 9-volt battery with the positive side
oriented as shown (
B
).
3. Replace the battery door by positioning the
bottom edge (
C
), and snap the battery door into
place.
To verify the battery has been inserted correctly
1. Press either button on the Remote Transmitter.
2. The Transmitter Indicator Light should come on.
3. If the Transmitter Indicator Light does not come on, you may have inserted a
bad or dead battery. Try taking it out and replacing it with one that is known
to be good.
4. If the Transmitter Indicator Light still does not come on, contact your PetSafe
Professional.
Prepare the Receiver Collar
To Insert and Remove the Batteries
1. With a coin, unlock the Battery Door and remove it (
D
).
2. Insert two 3-volt Lithium (CR2032 batteries) into the
Battery Door (
D
).
3. Place the Battery Door back into the Receiver (
E
).
4. With a coin, slide Battery Door latch to lock it (
E
).
To Pair the Remote Transmitter
and the ProTx
®
-Plus
Transmitter
If your Receiver Collar does not beep
when the Tone Only Button of the Remote
Transmitter is pressed, or if you feel the
Receiver Collar is not responding:
1. With the Receiver Collar off your pet,
Separate the Remote Transmitter and the
ProTx
®
-Plus Transmitter by no more than
10 feet.
2. Press both the top and bottom buttons (
F
)
on the Remote Transmitter at the same
time.
3. The ProTx
®
-Plus Transmitter should beep.
4. If the ProTx
®
-Plus Transmitter does
not beep, please contact your PetSafe
Professional.
Setting the Correction Duration and Us-
ing the Remote Transmitter
To set the Correction duration, press the “Program” button.
The ProTx
®
-Plus Transmitter will indicate the present
Correction duration by beeping once or twice. It will beep
once for a 1/2 second Correction and twice for a one second
Correction.
Program the system to the desired Correction duration;. The
Correction duration will be stored even if the containment
transmitter has been turned off.
Once you have set the system to the desired Correction
duration, you are ready to begin training.
When you press and hold the Stimulation and Tone Button,
your pet will receive a Correction for the duration set, then
there will be a one second pause before receiving another
Correction for the same duration, until the button is released.
Once your pet starts to associate the warning tone with the
Correction, you can press the Tone Only button to warn your
pet that if the behavior does not change, he will receive a
Correction.
Note: Remote will only work
with Receiver Collar inside
the containment area.
A
B
C
D
E
PROGRAM
+
F
