16 1-800-732-2677
www.petsafe.net 17
9. To test the run-through prevention feature, walk towards the Boundary Wire. The
Receiver Collar should tone and the Test Light should flash brighter as you enter the
run-through area (
6G
). If you are satisfied that your system is functioning properly, you
are ready to start burying the Boundary Wire. If the Receiver Collar did not tone or
the Test Light did not flash, see the “Troubleshooting” section.
Boundary
Wire
6G
Install the Boundary Wire
Before you begin installing the Boundary Wire, unplug the Fence Transmitter power adapter from the
outlet.
To Bury the Boundary Wire
Burying the Boundary Wire is recommended to protect it and prevent disabling the system.
1. Cut a trench
1-3 inches
deep along your planned boundary.
2. Place the Boundary Wire into the trench maintaining some slack to allow it to expand and contract with
temperature variations.
3. Use a blunt tool such as a wooden paint stick to push the Boundary Wire into the trench. Be careful not to
damage the Boundary Wire insulation.
To Attach the Boundary Wire to an Existing Fence
The Boundary Wire of the PetSafe
®
Stubborn Dog
In-Ground Fence
™
can be attached to a chain link
fence, split rail fence, or a wooden privacy fence. The
Boundary Wire can be attached as high as needed.
However, make sure the Boundary Width is set at a high
enough range for the pet to receive the signal. If using
a Double Loop with an existing fence at least five feet
tall, run the Boundary Wire on top of the fence and
return it on the bottom of the fence to get the five foot
separation needed.
• Chain Link Fence (7A)
: Weave Boundary Wire
through the links or use plastic quick ties.
• Wooden Split Rail or Privacy Fence (7A):
Use staples
to attach Boundary Wire. Avoid puncturing
STAPLE WIRE TO FENCE
WEAVE WIRE INTO FENCE
STAPLE WIRE
TO FENCE
7A
DOUBLE LOOP
5’
5’
SINGLE LOOP
7B
the insulation of the Boundary Wire.
• Double Loop with an Existing Fence:
Run the Boundary Wire on top of the fence and return it on the bottom of
the fence to get the five foot separation needed.
• Gate (Single Loop) (7B) :
Bury the Boundary Wire in the ground across the gate opening.
Note: The signal is still
active across the gate. Your pet cannot pass through an open gate.
• Gate (Double Loop) (7B):
Bury both Boundary Wires across the gate opening while keeping them at least 5 feet
apart.
Step
7
Summary of Contents for PIG00-100777
Page 31: ...www petsafe net 31...
