8
Customer Care Center 1-800-732-2677
STEP 2
Prepare the Receiver Collar
Charge the Receiver Collar
1. Lift the rubber cover protecting the Receiver Collar Charging Jack.
2. Connect one of the charger connectors to the Receiver Collar
Charging Jack (
2A
).
3. Plug the charger into a standard wall outlet. The red light will appear.
4. Charge the Receiver Collar for 24 hours for the first charge.
Recharges take only 12 hours.
Note: The Receiver Indicator Light is
solid green after 12 hours of charging. For the first charge, continue to
charge the Receiver Collar for an additional 12 hours.
5. When charging is completed, replace the rubber cover.
To Turn the Receiver Collar On
1. Press and hold the On/Off Button (
2B
) until the Receiver Indicator
Light comes on solid green and the Receiver Collar beeps low to high.
2. Release the On/Off Button.
The Receiver Indicator Light will flash green once every 5 seconds. The
flashing light indicates the Receiver Collar is on and ready to receive a
radio signal from the Handheld Remote.
To Turn the Receiver Collar Off
1. Press and hold the On/Off Button until the Receiver Indicator Light
comes on solid red and the Receiver Collar beeps high to low.
2. Release the On/Off Button.
To extend the life between charging cycles, turn the Receiver Collar off when it is not in use.
Approximate battery life between charges is 15-20 hours, depending on frequency of use.
On/Off Button
2B
Charger connector placed
in Receiver Collar
Charging Jack
2A
