12
Customer Care Center 1-800-732-2677
STEP 6
Program the Receiver Collar for Two or Three-Dog Operation
With the Handheld Remote set to Mode 6, 7 or 8, PetSafe
®
Add-A-Dog
®
Receiver Collars can be set
to respond to the Upper, Lower, or Side Remote Transmitter buttons. Add-A-Dog
®
receiver(s) must
be purchased to train additional dogs.
1. Program the Handheld Remote to Mode 6, 7 or 8.
2. Program the first Receiver Collar.
a. Turn the Receiver Collar off.
b. Press and hold the On/Off Button. The Receiver Indicator Light will come on, then turn off in
4-5 seconds. If the On/Off Button is released too early, the Receiver Indicator Light will begin its
normal flashing. If this occurs, start over and repeat the process.
c. After the Receiver Indicator Light has turned off, release the On/Off Button.
d. Press and hold the Upper Button on the Handheld Remote until the Receiver Indicator Light
flashes 5 times and beeps 5 times. You may need to hold both units 3 feet from each other. If
the Receiver Indicator Light does not flash 5 times, start over and repeat the process.
3. Program the second Receiver Collar following steps A. thru D. above, using the Lower Button in
place of the Upper Button.
4. Program the third Receiver Collar following steps A. thru D. above, using the Side Button in place
of the Upper Button.
