www.petsafe.net
www.petsafe.net
25
DE
IT
NL
ES
FR
EN
PIG20-11041
Little Dog Add-A-Dog
®
Receiver Collar
This unit has 4 adjustable levels of Static Stimulation plus a Tone Only mode.
Prepare the Receiver Collar
To Insert and Remove the Battery
Note: Do not install the battery while the Receiver Collar is on your pet.
This Receiver Collar utilises a replaceable PetSafe
®
battery (RFA-188).
This unique battery is designed to make battery replacement easier and
increase water protection.
To activate the collar, insert the battery module
(A)
. Using the edge of the
Test Light Tool as shown, turn the battery clockwise until the vertical line
on the battery is pointed to the “ON” position
(B)
. If the PetSafe
®
Receiver
Collar is not going to be used on the pet immediately, leave it in the
“OFF” position.
To remove the battery, turn the battery anti-clockwise using the edge of the
Test Light Tool as shown
(C, D)
.
Discharge all power by holding the Stimulation Level Button down until the
light is no longer illuminated. Replace with a new battery.
DO NOT attempt to cut into or pry open the battery. Be sure to discard the used battery properly.
A replacement PetSafe
®
battery can be found at many retailers. Contact the Customer Care Centre or visit our website at
www.petsafe.net to locate a retailer near you.
Static Stimulation and Battery Test Feature
When the RFA-188 Battery Module is first installed in the Receiver Collar, the red LED will flash the current stimulation level
setting (1 to 5). For the next 30 seconds, the Receiver Collar will monitor the battery status and will either flash the green LED
once every 5 seconds to indicate a good battery, or flash the red LED once every 5 seconds to indicate a low battery condition.
After the 30 second battery test period, the green LED will cease to flash if the battery is good. If the battery was low during
the test period, the red LED will continue to flash at a rate of 1 flash every 20 seconds to indicate a low battery condition. In this
situation, battery replacement is recommended.
See Step 5 to set the Static Stimulation Level.
Function and Response Table
Note: Begin training with Static Stimulation Level 2 and only increase if your pet does not respond to the Static Stimulation.
Indicator Light Response
Static
Stimulation Level
Receiver Collar Function
Temperament of Pet
1 Red Flash
1
No Static Stimulation, Tone Only
2 Red Flashes
2
Low Static Stimulation
Timid
3 Red Flashes
3
Medium Static Stimulation
Timid or Average
4 Red Flashes
4
Medium High Static Stimulation
Average or High Energy
5 Red Flashes
5
High Static Stimulation
High Energy
Flashes 1 Red Flash every
20 seconds
Low Battery
A
C
B
D
