Petsafe Drinkwell PAGODA-BL-AU-17, Operating Manual, Page: 7 / 19

www.petsafe.net 7
FR
IT
NL
DE
EN
ES
. Operating Instructions
Important:
DO NOT RUN DRY - FOR INDOOR USE ONLY. Monitor your Pet Foun-
tain periodically for the first 12 hours to make sure it is running properly.
Note:
Rinse all fountain parts with warm water
before operating the Pet Fountain. This will remove
any dust or residue that remain in the system from the
manufacturing process.
1. Carefully remove all the Pet Fountain
components from the packaging and set aside
prior to assembly.
2. As with any electrical device, check the electrical
power cord for any tears or damage before use.
3. Place the Foam Filter around the Pump by inserting
the Pump into the Foam Filter from the top, make
sure the electrical power cord rests on top of the
Foam Filter (
Fig.1
).
4. Take the Bowl and place the Pump inside the
square indention. With the Bowl positioned so
the raised post is at the top right corner of the
square, make sure the Pump is positioned so that
the Pump Outflow, the circular opening on the
top of the Pump, is positioned in the bottom left
corner of the square ( Fig. 2 ).
5. Press down on the Pump to engage the suction
cups. Once the Pump is securely in place, feed
the In-Line Plug of the electrical power cord over
and through the raised post and out the notch in
the base of the Bowl (
Fig. 3
).
6. Remove the extra slack from the electrical power
cord and insert the Rubber Cap into the raised
post. Make sure the cord channel on the Rubber
Cap is aligned with the electrical power cord,
then insert your finger into the Rubber Cap and
push all the way down (
Fig. 4
).
7. Fold the top of the Rubber Cap over the raised
post to seal off the Bowl (
Fig. 5
).
Electrical
power
cord
rests on
top
Fig. 1
Pump
Outflow
Fig. 2
Fig. 3
Fig. 4
Cord channel
Fig. 5