www.petsafe.net 13
12 www.petsafe.net
EN
ES
FR
IT
NL
DE
.
5. Once the Pump is completely disassembled,
you can clean the parts with warm water and
soap. Use a cotton swab or the “motor brush”
from the Drinkwell
®
Cleaning Kit to clean
inside the Pump’s motor cavity and remove
any build-up (
Fig. 16
). For added disinfecting
and hard water removal, clean the Pump’s
motor with a diluted white vinegar solution
(20% white vinegar and 80% water).
Important:
Be sure to rinse thoroughly
with fresh water.
6. Once the parts are clean and well rinsed, you can reassemble the Pump for use.
a) Replace the Impeller.
b) Replace the Intake Plate.
c) Replace the Faceplate.
Pet Fountain Reassembly
1. Place the Foam Filter around the Pump (
Fig. 17
).
Take the Bowl and place Pump inside the square
indention. With the Bowl positioned so the raised
post is at the top right corner of the square, make
sure the Pump is positioned so that the Pump
Outflow is positioned in the bottom left corner of
the square (
Fig. 18
).
2. Press down on the Pump to engage the suction
cups. Once the Pump is securely in place, feed
the In-Line Plug of the electrical power cord over
and through the raised post and out the notch in
the base of the Bowl (
Fig. 19
).
Fig. 16
Electrical
power
cord
rests on
top
Fig. 17
Pump
Outflow
Fig. 18
Fig. 19
Notch
