www.petsafe.net
11
Prepare the Receiver Collar
Charge the Receiver Collar
1. Lift the rubber cover protecting the Receiver Collar Charging Jack.
2. Connect the charger connector to the Receiver Collar Charging Jack.
3. Plug the charger into a standard wall outlet.
4. Charge the Receiver Collar until the Green Indicator Light comes on and is solid.
Recharges take only 3-4 hours.
5. When charging is completed, replace the rubber cover.
Little Dog Receiver Collar
Big Dog Receiver Collar
Charger connector
placed in Receiver
Collar Charging Jack
Charger connector
placed in
Receiver Collar
Charging Jack
To Turn the Receiver Collar On
1. Press and hold the On/Off button until the Green LED comes on and the Receiver
Collar beeps low to high.
2. Release the On/Off button. The Green LED will flash once every 5 seconds until the
Receiver Collar is turned off. The flashing light indicates the Receiver Collar is ready
to receive a radio signal from the Remote Transmitter.
3. Once the Receiver Collar has been turned on, press the Tone (upper left button) of the
Remote Transmitter. Upon pressing, the Receiver Collar should beep for as long as the
Upper Left button is pressed. If it does not, see “To Pair the Remote Transmitter and
the Receiver Collar”.
Note: To extend the life of the battery, turn the Receiver Collar off
when it is not in use.
Little Dog Receiver Collar
Big Dog Receiver Collar
On/Off
Button
(On bottom
of receiver)
On/Off
Button
Step
2