EPD EXT2 with Cypress PSoC 4 BLE module
9
[User’s Guide] Rev.01
2.
Getting Started
This section provides instructions to set up the EXT2 kit with Cypress PSoC 4 BLE kit and use
the PSoC Creator to update image on EPD display.
There are two steps to prepare the kit:
(1)
Assembling the EXT2 board with Cypress PSoC 4 BLE kit
(2)
Programming firmware to PSoC 4 BLE kit
2.1
Assembling the EXT2 board with Cypress PSoC 4 BLE kit
We will need to set the jumpers of Cypress PSoC 4 BLE kit in order to get works at a proper
system voltage and programmable.
2.1.1
Adjust the Jumpers of Cypress PSoC 4 BLE kit
Cypress PSoC 4 BLE kit
-
System power supply jumper(J16):
-
BLE power supply jumper/current measurement(J15)
