EPD EXT2 with Cypress PSoC 4 BLE module
11
[User’s Guide] Rev.01
2.1.4
How to bridge EXT2 with other development kit
If you will use our EXT2 board to bridge with your product or other development kit, there is
Bridging header (
J5
) which is pin-to-pin to J4 and J6. The pin assignment is listed on the front
side of PCB. Please use the 90 degree 20-pins header to solder on the backside of PCB like
the picture below.
We highly recommend cutting the protruding portion of the pin header in order to avoid
breaking the EPD.
After soldering the header on the EXT2 board, you are able to connect the bridging cable
with the pin headers of other development kit or your product.
Please note there is a white dot on the connector of bridging cable indicates the pin 1.
