Perry Electric 1TX RX01/P, Manual, Page: 9 / 60

9
5 s
5 minutes
Fig. 3 Fig. 4
RESET
Fig. 5
2.2 - NEW DEVICE
When turned on, the receiver has only the lit.
ON LED
N.B.: lower There may be a weak lighted signal on the of the , due to the presence of radio interference. LED VMETER
2.3 - TEMPORARILY FORCING THE STATE OF THE CONTROL OUTPUT (for example, to test the system)
B) TRANSMITTER COUPLED AND HEAT REGULATION ACTIVE
The above-indicated operations can also be performed, using the same methods, during normal heat regulation operation; in this case,
the temporary forced control will cause the transmitter to be excluded and the reversal of the command status: if active, it will be
deactivated and vice versa. During the forced state, the “
” is not functional. key
Cancelling the temporary forcing of the control
!
Briefly press the ; when released the temporary forced control is
“ ” Reset key
cancelled (fig.5).
N.B.: Reset Before performing this operation, consult chapter 2.9 “ ”
A) TRANSMITTER NOT YET COUPLED OR NOT ACTIVE
!
Hold down the “ ” until there is a brief audible signal, then release it: the control is activated and the corresponding is key LED
steady on (fig.3).
The control will remain activated for 5 minutes, at the end of which, an audible signal will continue for to alert the operator of 5 seconds
its imminent deactivation (fig.4): if you wish to keep it active, press the “ ” again while the audible signal is sounding; key
otherwise, when the signal ceases, the control will be deactivated.
E
N