Perry Electric 1TX RX01/P, Manual, Page: 12 / 60

12
ON
Fig. 11
4 s
6 s 4 s 1 s 1 s 1 s
RESET
ON
2
s
Fig. 12
Fig. 13
2.7 - SIGNALING A TRANSMITTER MALFUNCTION
The receiver reports two types of transmitter anomalies:
!
Failure to receive a radio signal for more than 30 minutes
!
Transmitter battery almost dead
In both cases, the signal is given by the intermittent, simultaneous lighting of the and ON
channel . LEDs
ATTENTION: in the case of the lack of a radio signal, the control of the load is also
deactivated (Burner control deactivated).
2.8 - DELETING A TRANSMITTER COUPLING FROM THE RECEIVER
(even in a state of malfunction)
It is possible to delete a transmitter coupling even if it is not able to transmit the Test signal.
!
Press and hold the “ ” until the end of the sequence of beeps shown in the figure; then release it. key
The transmitter coupling is erased from the memory of the receiver and the channel is free.
ATTENTION: in the event the key is released before the
beginning of the long beep, the operation is automatically
cancelled and the command output is set to
“Temporary
Forced” (see paragraph 2.3).
Press to return to normal operation. “ ” RESET Key
2.9 - RESET
When the key is released during this period of
time, the operation is cancelled
The command on the receiver cancels all the data stored in the device RESET
except for the transmitter coupling.
!
Briefly press the : when it is released, will light RESET key LEDs all the
together with a and the will be steady lit. beep ON LED
E
N