10
O
2
asis User Guide
3
The first time using the Water Fill Pump:
Hold the pump collar in one hand. Use the other hand
to twist pump head
COUNTER-CLOCKWISE
.
Twist until the pump
SPRINGS UP
.
4A
Push (1) and then twist (2) the connector
at the end of the Water Fill Pump hose
to the Water Well fill port.
4B
Slowly push down on the water fill pump handle 5 times
to fill the Water Well.
As needed, remove Water Well to visually check water
level, see section Checking for an empty Water Well,
page 18. To prevent over-filling, the pump should not
be used while the Water Well is disconnected from the
Base Unit.
Confirm that the electrical port is dry and reattach the
device to an electrical outlet. If the device is overfilled,
the soft portion of the Water Well may balloon, create
difficulties in closing the blue latch, and cause it to dis-
connect from the base unit. If this happens, unplug the
device and allow it to run for several minutes without
power. When the ballooning has subsided, the device
can be reconnected to power and used normally
x5
4C
Remove the Water Fill Pump hose from the fill port. Set
aside the gallon and Water Fill Pump until need to refill.
Collar
2
1
PP-19-1 REV. 15
