Perle 10/100/1000 Media Converter Module – Installation Guide
12
Down
Enabled
Disabled: This is the setting for normal operation. The
switch must be set to this position in order for data to
pass through the Media Converter Module.
Enabled: This is a test mode. All data received on the
receive (RX) fiber connection is looped back to the
transmit (TX) fiber connection. The state of the copper
link is not relevant since no data is passed through to
the copper side. This mode will override all other switch
settings.
Installing or Replacing Media
Converter Modules
Caution: Observe electrostatic discharge precautions
when installing the Media Converter Module(s) into the
Chassis. Failure to observe this caution could result in
damage to the Media Converter Module(s) and /or
chassis.
The Perle Media Converter Modules can be installed in
any available slot and in any order within the chassis.
1. Remove the Media Converter Module from its
packaging.
2. Using a cross-head screwdriver, remove the screw
holding the face plate to the Chassis to reveal the
slot opening.
3. Set the jumpers and DIP switches on the Media
Converter Module to the desired operating mode.
4. Locate the top and bottom alignment guides inside
the Chassis.
5. Using the module alignment guides gently slide the
module into the slot until it becomes flush with the
