Remove the front load ring before returning the
engine to service, to prevent the last load ring from
rubbing on the fan belt.
Engine and Installed Radiator Only
The engine lifting eyes are rated to lift an engine with
attached radiator, assuming a less than 5 degree tilt
angle can be maintained. Be sure to use an
appropriate spreader set so that lifting chains are
perpendicular to the engine.
Radiator Only
Detach the radiator, and mounting bracket at the
engine front support. Add eyebolts or lifting brackets
to the threaded holes marked for lifting.
Clean Emission Module Lifting
Illustration 42
g06251427
(3) Clean Emission Module (CEM) lifting eye locations
Detach the Clean Emission Module (CEM) and use
the lifting eyes attached to the CEM support for lifting.
Care must be taken to identify the center of gravity of
the CEM.
NOTICE
Do not attempt to use the radiator or CEM lift points
to aid in the engine package lift.
Pump Tank Unit (PTU)
Illustration 43
g06251429
(4) Diesel Exhaust Fluid (DEF) and electronic unit lifting locations
i07249571
Product
Storage
(Engine
and
Aftertreatment)
Your
Perkins
distributor
can
help
in
preparing
the
engine
for
extended
storage
periods.
Some
applications,
the
engine
can
be
equipped
with
delayed
engine
shutdown.
Allow
at
least
2
minutes
after
the
engine
has
stopped
before
you
turn
the
battery
disconnect
switch
to
OFF.
Disconnecting
the
battery
power
too
soon
will
prevent
purging
of
the
DEF
fluid
lines
after
the
engine
is
shut
down.
Also,
during
the
2
minutes
the
engine
electronic
control
module
is
active
storing
information
from
the
engine
and
aftertreatment
sensors.
Condition
for
Storage
An
engine
can
be
stored
for
up
to
6
months
provided
all
the
recommendation
are
adhered
to.
M0087475-06
37