94
SEBU8603-01
Maintenance Section
Engine Crankcase Breather Element - Replace
7.
Remove the container.
Bottom Service
Ensure that dirt cannot enter the breather assembly.
g02346498
Illustration 56
(X) Alignment mark
(Y) Alignment mark
1.
Ensure that the outside body of the breather
assembly is clean and free from damage. Place
a container under the breather.
2.
Remove the tube connection (1). Ensure that
dirt cannot enter the tube connection. Note the
position of the alignment marks (X and Y). Rotate
the bottom cap (2) counterclockwise in order to
release the cap and the
fi
lter element (4) from the
breather body (3).
g02346499
Illustration 57
Typical example
(A) Alignment postion
(B) Alignment postion
3.
Note the orientation of the
fi
lter element. Remove
the
fi
lter element (4) from the bottom cap (2).
Remove the seal (5).
Note:
The bottom cap has a section that allows
access in order to remove the seal.
4.
Install a new seal (5). Install a new
fi
lter element
into the bottom cap (2).
5.
Align position (A) on the
fi
lter element to position
(B) on the top cap. Refer to illustration 57.
6.
Install the assembly of the
fi
lter element and the
bottom cap (2). Rotate the bottom cap by hand
clockwise until the bottom cap locks into the
locked position on the breather body. Ensure
that the alignment marks (X and Y) are correctly
aligned. Refer to illustration 56.
7.
Install tube connection (1). Ensure that the
retaining clips on the tube connection are correctly
engaged. Remove the container.