2.
Check the stop lever bracket retaining bolts (8) are
securely tightened.
3.
Check the solenoid ball joint stud (2) is securely
attached to the stop lever (1) on the fuel injection
pump.
4.
Check that the nut (5) is secure. If necessary hand
tighten the nut.
5.
Check that the solenoid locking nuts (6) are
securely hand-tightened.
6.
Check that the solenoid attachment bracket (3) is
not damaged and is securely tightened to the
engine block.
Lubricate with Grease
Illustration 43
g06428411
Typical example
The stop lever on the fuel injection pump and the
actuating mechanism on the solenoid (7) needs to be
lubricated at specific intervals.
Lubricate the stop lever attachment points (8) on the
fuel injection pump with suitable grease at a service
interval of every 300 hours.
Lubricate the solenoid ball joint stud (2) with suitable
grease at a service interval of every 6 months.
Lubricate with Engine Oil
The stop lever on the fuel injection pump and the
actuating mechanism on the solenoid needs to be
lubricated at specific intervals.
Lubricate the solenoid ball joint plunger (4) and
plunger seal with clean engine oil at a service interval
of every 6 months.
i07754449
Fuel
Injector
-
Test/Change
Fuel leaked or spilled onto hot surfaces or electri-
cal components can cause a fire.
NOTICE
Do not allow dirt to enter the fuel system. Thoroughly
clean the area around a fuel system component that
will be disconnected. Fit a suitable cover over any
disconnected fuel system components.
NOTICE
If a fuel injector is suspected of operating outside of
normal parameters it should be removed by a quali-
fied technician. The suspect fuel injector should be
taken to an authorised agent for inspection.
M0105633-01
65
