• Push the table saw to the desired location then either open
the stand for saw operation or store the table saw in a dry
environment.
HEIGHT/BEVEL ADJUSTING HANDWHEEL
Refer to Figure 15.
• Turn the height adjusting knob clockwise to raise the blade,
and counterclockwise to lower the blade.
• Turn the handwheel clockwise, and move along the arc rail,
then the blade will bevel from 0° to 45°, or turn
counterclockwise.
• Secure the blade bevel lock lever when the bevel angle
pointer points at desired angle on scale. To lock the blade, turn
blade bevel lock lever clockwise. To unlock the blade, turn
it counterclockwise.
Lower the blade by:
• Turn the height adjusting knob counterclockwise to lower the
blade.
• Lock the blade by turning bevel lock lever clockwise.
TO REMOVE/REPLACE/ALIGN THE TABLE INSERT
Refer to Figures 16-17.
WARNING:
The table insert must be level with the saw
table. If the table insert is too high or too low, the workpiece can
catch on the uneven edges resulting in binding or kickback
which could result in serious personal injury.
Turn the height adjusting knob counterclockwise to lower the
blade to the lowest position. Lock the blade by turning bevel
lock lever clockwise.
•
To remove the table insert:
Place your index finger in the
Hole and lift the front end, pulling the throat plate out toward
the front of the saw.
•
To reinstall the table insert:
Slip the tab into the slot at the
back of the saw and push down to secure in place.
ASSEMBLY
_ 18 _
Figure 15
Figure 16
