• Attach two shock absorption pads (6) to the stand support (1)
with two M8 x 60 Socket Head Bolts (10), M8 flat washers (8)
and M8 hex nut (11).
• Slide one M10 big flat washer (12), roller sleeve (13),
wheel (14) and M8 big flat washer (15) and M8 hex nut (11) on
the axle through the hole in the center of the wheel (14).
Secure in place using the adjustable wrench or 13mm wrench
Repeat with the second wheel (14).
• Attach the handle assembly to leg stand assembly (2) with
two M6 x 35 socket head bolts (16) and M6 hex nuts (17) as
shown in Figure 4.
• Figure 5 is complete open leg stand assembly.
• Place the leg stand on a level surface and level the stand to
the floor.
NOTE:
Be sure that the leg stand is securely locked in an open position and that the shock absorption pad stabilized the
table saw before operation.
WARNING:
DO NOT OPERATE THIS MACHINE ON THE FLOOR. THIS IS A VERY DANGEROUS POSITION.
TO SECURE/LEVEL THE TABLE SAW
Refer to Figure 6
.
With the stand open and the table saw resting on a flat
and level surface, the table saw should not move or rock
from side to side. If the table saw rocks from side to side,
the leveling foot need adjusting until the stand is
balanced.
• Loosen the locking knob counterclockwise.
• Lift the table saw slightly so that you may turn the
leveling foot until the stand no longer rocks.
• Turning clockwise will lower the foot.
• Turning counterclockwise will raise the foot.
ASSEMBLY
Figure 6
_ 14 _
Figure 5
