2
SPECIFICATIONS
Specifications are
subject to change
without notice
IMPORTANT SAFETY INFORMATION
WARNING!
READ, UNDERSTAND AND FOLLOW ALL INSTRUCTIONS AND
WARNINGS BEFORE OPERATING THIS TOOL. FAILURE TO DO
SO MAY RESULT IN PERSONAL INJURY AND/OR PROPERTY
DAMAGE AND WILL VOID WARRANTY.
1. Keep work area clean. Cluttered areas invite injuries.
2. Observe work area conditions. Do not use machines or power tools in damp or wet
locations. Don’t expose to rain. Keep work area well lighted. Do not use electrically
powered tools in the presence of flammable gases or liquids.
3. Keep children away. Children must never be allowed in the work area. Do not let them
handle machines, tools, or extension cords.
4. Store idle equipment. When not in use, tools must be stored in a dry location to inhibit
rust. Always lock up tools and keep out of reach of children.
5. Use the right tool for the job. Do not attempt to force a small tool or attachment to do
the work of a larger industrial tool. There are certain applications for which this tool was
designed It will do the job better and more safely at the rate for which it was intended.
Do not modify this tool and do not use this tool for a purpose for which it was not
intended.
6. Dress properly. Do not wear loose clothing or jewelry as they can be caught in moving
parts. Protective, electrically non-conductive clothes and non-skid footwear are recom-
mended when working. Wear restrictive hair covering to contain long hair.
7. Use eye and ear protection. Always wear ANSI approved impact safety goggles.
8.
Work Safe. Keep proper footing and balance at all times. Never use cross bars as step
ladder, nor stand on workbench top. Never exceed recommended maximum weight ca
-
pacity of Workbench (200lbs.). Always lower heavy loads onto Workbench gently, so that
strain is taken up gradually. Do not reach over or across running machines, hoses, etc.
9. Stay alert. Watch what you are doing, us common sense. Do not operate any tool when
you are tired.
10. Check for damaged parts. Before using any tool, any part that appears damaged
should be carefully checked to determine that it will operate properly and perform its
intended function. Check for alignment and binding of moving parts; any broken parts
Height: ....................................................... 31 In.
Length: ................................................ 23 7/8 In.
Width: ........................................................ 25 In.
Jaw Opening: ...................................0 - 4 1/4 In.
Weight Capacity: ................................... 200 Ibs
Work Surface: ........................ 23 7/8 x 9 7/16 In
..............
Fully Extended - 23 7/8 x 13 11/16 In.
Vise Capacity: .............................7/8 - 10 1/2 In.
