3
IMPORTANT SAFETY INFORMATION
or mounting fixtures; and any other condition that may affect proper operation. Any
part that is damaged should be properly repaired or replaced by a qualified technician.
11. Replacement parts and accessories. When servicing, use only identical replacement
parts. Use of any other parts will void the warranty. Only use accessories intended for
use with this tool Approved accessories are available from Performance Tool
®.
12. Do not operate any tool if under the influence of alcohol or drugs. Read warning labels
on prescriptions to determine if your judgment or reflexes are impaired while taking
drugs. If there is any doubt, do not operate any tool.
13. Maintenance. For your safety, maintenance should be performed regularly by a quali
-
fied technician.
WARNING:
This product and its packaging contain a chemical known to the State of
California to cause cancer, birth defects, or other reproductive harm.
WARNING:
The warnings, cautions, and instructions discussed in this instruction manual
cannot cover all possible conditions and situations that may occur. It must be understood
by the operator that common sense and caution are factors which cannot be built into this
product, but must be supplied by the operator. Read and understand all of the instructions
provided in the instruction manual of the Work Bench, as well as, any other tool (s) used
with the Work Bench.
• Screwdriver (phillips head no. 2) • Hammer • Spanner (included in package)
1. Use bolts (9), washers (13) and nuts
(10) to connect crossbars (4) and leg
frames (5).
2. Use wood screws (8) to connect slide
bases (2) and work tops (1).
3. Fit leg frames (5) into slide bases (2),
line up holes in slide base with holes in
leg frame insert bolts (3) and washers
(7) from outside of the base and attach
washers (7) and nuts (11) from inside
use screwdriver and spanner to tighten
screws.
4. Attach plastic feet (6) to the legs
(5). Each foot Must be attached with
longest side at outer corner which is
indicated by arrow inside.
5. Select suitable holes on the work tops
for bench dogs (12).
TOOLS REQUIRED
ASSEMBLY INSTRUCTIONS
