7
STEP 2:
INSTALL TOP ANGLE AND
SIDE BRACKET
1. Attach foam gasket to top angle above holes, as
shown in Fig. 6 on previous page.
2. Install top angle and side retainers to cabinet, as
shown in Fig. 8. (10 screws)
FIG. 8
5/16
″
long
hex-head
STEP 3:
ASSEMBLE ACCORDION PANELS
1. Place cabinet on floor, a bench, or a table.
2. Slide “ ” section of window filler panel into side
retainer on the side of the cabinet. (See Fig. 9 and
Fig. 10.) Do this on both sides.
FIG. 9
FIG. 10
Accordion
Panel
Air Conditioner
Cabinet
Top
View
Plastic
Frame
Locking
Screw
Hole
Accordion
Panel
“ “ Section
Side Retainer
Plastic
Frame
3. Insert top and bottom legs of window filler panel
frame into channel in the top angle and bottom rail.
Do this on both sides.
4. Insert washer head locking 7/16″ screws (2) into
holes in top leg of filler panel frame. (See step 6 on
next page.) Do not totally tighten. Allow leg to slide
freely. Screws will be tightened after step 6.
STEP 4:
PLACE CABINET IN WINDOW
1. Open window and mark center of window sill.
(Fig. 11)
2. Place cabinet in window with bottom sill angle
firmly seated over window sill as shown. Bring
window down temporarily behind top angle to hold
cabinet in place. (Fig. 12)
FIG. 12
FIG. 11
Sill
Angle
Sill
3. Shift cabinet left or right as needed to line up
center of cabinet on center line marked on sill.
4. Fasten cabinet to window sill with 2 screws into
holes. (You may wish to pre-drill pilot holes.)
5. Add bottom rail seal over screw to window sill.
(See Fig. 13 on next page.)
