5
Please read ALL instructions before installing. It is
recommended that two people install this product.
If a new electrical outlet is required, have the outlet
installed by a qualified electrician before installing the
air conditioning unit.
Window Sash Seal
Top Angle
Foam Gasket
Side Retainer
Locknut
Safety Lock and
3/4
″
(or 1/2
″
)
Long Hex Head Screw
1/2
″
Long
Screw and
Locknuts
Washer Head
Locking Screw
Seal Bottom
Rail to Unit
Frame
Assembly
(Left)
Frame Assembly
(Right)
3/4
″
Long
Flat Head
Bolt
Sill Angle
Bracket
Window Support
Bracket
FIG. A
SASH
SASH
19
″
MIN.
19
″
MIN.
1/2
″
MIN.
1/2
″
MIN.
1/2
″
MIN.
Board
thickness
as required
along entire
stool. Fasten
with 2 Nails
or Screws.
Storm window
frame or other
obstruction
Storm window
frame or other
obstruction
FIG. B
FIG. C
PRELIMINARY INSTRUCTIONS
Do the following before installing the unit. (See
illustrations on left.)
Check dimensions of your unit to determine proper
window dimensions:
Unit Height:
17
5
/
8
or 18
5
/
8
Unit Width:
23
5
/
8
or 26
1
/
2
Min. Window Height: 18
1
/
2
or 19
1
/
2
Min. Window Width: 28
or 31
Max. Window Width: 40
1
/
2
or 42
1. CHECK WINDOW OPENING SIZE
— The mounting parts
furnished with this air conditioner are made to install
in a wooden sill, double-hung window. The standard
parts are for window dimensions listed above. Open
sash to a minimum of 19 in. (483 mm). See Fig. B .
2. CHECK CONDITION OF WINDOW
— All wood parts of
window MUST be in good shape and able to firmly
hold the needed screws. If not, make repairs before
installing unit.
3. CHECK YOUR STORM WINDOWS
— If your storm
window frame does not allow the clearance required,
correct by adding a piece of wood, as shown in
Fig. C, or by removing storm window while room air
conditioner is being installed.
4. CHECK FOR ANYTHING THAT COULD BLOCK AIRFLOW
—
Check area outside of window for things such as
shrubs, trees, or awnings. Inside, be sure furniture,
drapes, or blinds will not stop proper airflow.
5. CHECK THE AVAILABLE ELECTRICAL SERVICE
— Power
supply MUST be the same as that shown on the
unit serial nameplate. Power cord is 48 inches long.
Be sure you have an outlet near. DO NOT use an
extension cord.
6. CAREFULLY UNPACK THE AIR CONDITIONER
— Remove
all packaging material. Cover the floor during
installation to prevent damage. Two people should be
used to move and install unit.
