Perfect Aire 3PATW14002, User Manual

Page: 15 / 28

12
#6 WHIRLPOOL
171/8 IN. DEEP
1. Remove existing rear grille and replace with provided
louvered panel. Install as shown here.
NOTE: You may need to drill holes in flange of existing
sleeve to match new rear grille.
2. Cut (2) 17
ʺ
Tapered Spacer Blocks as shown below into
two pieces.
TAPERED
SPACER BLOCK
CUT HERE
PROTECTION
PAPER BACKING
3/4
ʺ
17
ʺ
1
ʺ
13
ʺ
3. Install 13
ʺ
section to the floor of the sleeve as shown.
This helps induce a rearward slope on the unit.
4. Attach (1) 1
ʺ
x ⅜
ʺ
x 25
ʺ
long seal in the center at the
top of the sleeve. Remove the backing paper and press
into position.
5. Attach (2) 1
ʺ
x ⅜
ʺ
x 14
ʺ
long seals to the left and right
sides of the sleeve.
6. Cut (2) 1
ʺ
x ⅜
ʺ
x 25
ʺ
long seal to 14
ʺ
long and attach it to
the vertical sections of the rear grille as shown.
7. Center unit and gently slide unit into sleeve.
8. Before sliding all of the way back, remove second screw
from front on left side of the unit.
9. Remove the plastic washer from the screw.
10. Screw and attach the other end of the ground wire to
the unit as shown in picture. Make sure that the toothed
washer is against the cabinet.
11. Slide the unit completely to the rear to ensure a
good seal, making sure the ground wire does not
become tangled.
12. Seal & frame the unit as described on page 17.
13. If you have difficulty with mounting the grille to the
sleeve, follow the instructions for direct mounting on
page 16.
WALL SLEEVE BRANDS:
REAR LOUVERS
4.5
ʺ
4
ʺ
80° 80°
80°80°
30° 30°
TOP VIEW
4.5
ʺ
4
ʺ
4
6 6
5
2