-5-
Auto defrost
indicator light
TIMER
Clean filter
indicator light
Bucket full
indicator light
Continuous operation
indicator light
On
Off
Defrost Full
CONT.
POWER
COMFORT FILTER
TURBO
ION
Timer on/off
indicator lights
High fan (Turbo)
indicator light
Ion operation
indicator light
Comfort dehumidifying
operation indicator light
Control Pads:
When you push the button to change
operation modes, the unit will make a single "beep"
sound to indicate that it is changing modes.
Comfort
Utilize this dehumidification mode to automatically
control humidity in the 45%-55% range based on
room temperature. When operating in this mode the
Down (
�
) and Up (
�
) pads will be deactivated and
you will NOT be able to set a desired humidity.
Continuous (Cont.)
Press to activate the continuous dehumidifying
operation. When operating in this mode the Down
(
�
) and Up (
�
) pads will be deactivated and you will
NOT be able to set a desired humidity. The unit will
run non-stop.
Timer
Press to initiate the Auto start and Auto stop feature,
in conjunction with the
�
and
�
key pads. The timer
range is 0.0 to 24 hrs. Timer does not cycle.
Down (
�
) and Up (
�
)
Use to set the desired humidity (when not in
comfort or continuous modes):
• The humidity level can be set within a range of
35%RH (Relative Humidity) to 85%RH (Relative
Humidity) in 5% increments.
• For drier air, press the
�
pad and set to a lower
percent value (%).
• For damper air, press the
�
pad and set a higher
percent value (%).
• The recommended standard setting is 45-50%.
You must be on Normal mode to set the humidity.
Use to set the timer:
• Instructions for setting the timer can be found on the
next page.
Display
Shows the set % humidity level from 35% to 85% or
auto start/stop time (0-24) while setting, then shows
the actual ( +/- 5% accuracy) room % humidity level
in a range of 30%RH (Relative Humidity) to 90%RH
(Relative Humidity).
Power
Press to turn the dehumidifier on and off.
Ion
When this button is pressed, the corresponding light
is illuminated and the ion generator will help remove
pollen and impurities from the air, trapping them in
the filter. Press the button again to stop this function.
Turbo
Controls the fan speed. Press to select High
("Turbo") speed (light illuminates) for maximum
moisture removal. When the humidity has been
reduced and quiet operation is preferred, set the fan
control to Normal by pressing the "Turbo" button to
turn off "Turbo" mode/light.
Filter
The check filter feature is a reminder to clean the Air
Filter for more efficient operation. The "Filter" light
(Clean Filter Indicator Light) will illuminate after 250
hours of operation. To reset after cleaning the filter,
press the Filter pad and the light will go off.
Control Pads On The Dehumidifier
NOTE: The control panel of the unit you purchased may be slightly different according to the models.
Fig. 1
