Installation and Operation Manual for the
Perenio®
PEACG01 Control Gateway
©Perenio IoT spol s r.o. All Rights Reserved
Doc Version: 2.0.0
Page
21
of
32
2.2 Reset to Factory Settings
The reset to factory settings of the Control Gateway shall be performed in the case of
any errors or connection failures occurred during the activation process. The reset to
factory settings procedure shall be performed as follows:
1.
Press and hold the Reset button for at least 10 seconds (You can find it on the
side of the Control Gateway – see Figure 2).
2.
Release the Reset button after all LED Indicators on the Control Gateway blink
three (3) times
. Wait until the Power Indicator lights up (For cases when the
device was not activated in the Mobile App) and the CG reappears in the lists of
available Wi-Fi Networks as an Access Point, or until both the WAN and the
Power Indicators light up (For cases when the device was already activated in
the Mobile App). As a rule, the reset to factory settings shall not take more than
three (3) minutes.
After completion of the reset process, the Control Gateway is considered ready for
operation or reactivation in the Mobile Application.
NOTE.
The reset to factory settings is possible only if the Control Gateway is
powered on.
It is not recommended to perform the factory reset until the Control Gateway is
deactivated in the Mobile Application (Valid for Devices already being activated in
the User Account).
3.
2.3 Ethernet Connection
The Control Gateway can be connected to the Internet in one of the following ways:
Wi-Fi Connection;
Connection via an Ethernet cable.
ATTENTION!
The initial connection of the Control Gateway to the Perenio Smart
App
MUST BE
performed over Wi-Fi, i.e. the Ethernet cable can be used when
reconnecting the device.
