SCAMSETW3
PEREL
4
5. Description Receiver (fig. 4)
1. Power switch
2. Antenna socket
3. Power socket
4. A/V output
5. Antenna
6. Channel button
7. Channel indicator
6. Installation
1. Put the camera in the desired location and then adjust the angle.
2. Turn on the camera by tuning the power switch from
OFF
to any channel. The power indicator lights green.
Remark:
The camera with built-in Li-battery has an autonomy of at least 5 hours. If the battery is dead, please recharge it with
the camera adapter (DC 5V 700mA). The charge indicator lights red during charging and turns dim when the battery
is fully charged. A full charge will take about 2 hours.
3. Connect the antenna with the receiver.
4.
Connect the adapter (DC 8V 200mA) to the receiver. Slide the power switch to the
ON
position.
5.
Connect the receiver to a monitor/TV with the A/V cable (yellow for video and red for audio).
6.
Power on the monitor/TV and select
A/V
mode.
7. Use the channel button to s
et the same channel on the receiver as on the camera .The camera picture is now
displayed on the monitor/TV.
8. Adjust the focus with the focus tuner on the side of the device (top right-hand corner)
.
9. Adjust the brightness, contrast and colour of the monitor/TV.
7. Camera Channel Set-up
Use the channel switch at the back to choose one of the four
available cameras. Select a different camera in case of interference
(see fig.).
8. General Guidelines
•
Protect the device against water and don't put objects containing water (e.g. vases) on top of the device
•
Turn off the camera/receiver if the system is not in use.
•
Use the adapter to connect /disconnect the device with/from the mains.
•
Do not cut off the DC power cable to try and use it with a different power source
9. Specifications
Operating Temperature
0 to +50°C/ +32 to +122°F
Storage Temperature
-30
to +80°C/ -22 to +176°F
Operating Humidity
85%RH
Summary of Contents for SCAMSETW3
Page 2: ...SCAMSETW3 PEREL 2...
