![background image](http://html1.mh-extra.com/html/perel/abc16al/abc16al_user-manual_1528360002.webp)
ABC16AL – JUMP LEAD – 16mm²
1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could harm the
environment. Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken to a
specialized company for recycling. This device should be returned to your distributor or to a local recycling
service. Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing Perel! Please read the manual thoroughly before bringing this device into service. If the device was
damaged in transit, don't install or use it and contact your dealer.
2. Safety Instructions
•
Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the dealer will not
accept responsibility for any ensuing defects or problems.
•
Consult your car owner manual for complete details.
•
Lead-acid batteries contain sulphuric acid. Avoid contact with skin, eyes or clothing.
•
The improper connection of jump leads presents an explosion hazard. Follow the recommended procedures.
•
Do not smoke or use an open flame near batteries.
•
Remove vent caps and check the liquid level before jump starting. If the liquid is not visible or appears to be frozen, do not
attempt to jump start.
•
Only start batteries of the same voltage.
•
Wear safety glasses.
3. Instructions
•
Connect the red clamp to the positive (+) terminal of
the dead battery first and then to the positive (+)
terminal of the good battery.
•
Connect one black clamp to the negative (-) post of
the good battery.
•
Connect the other black clamp to the engine block of
the stalled car as far away from the battery as possible. Direct connection to the negative (-) terminal of the dead battery is
also possible but not recommended.
•
Step away from the car being boosted before engaging the starter of the stalled car.
•
Do not use the jump leads after cranking continuously for 10 ~ 15 seconds. Wait for about 1 minute and try again. If you
can still not start the stalled car, the problem might be due to a mechanical or electrical failure, and not the battery.
•
After starting, keep both engines running and remove the clamps immediately, reversing the procedure: remove the black
clamp at the engine block first.
4.
Technical Specifications
Cable Section
16mm²
Capacity
max. 220A
Cable Length
3m
Velleman nv cannot be held responsible in the event of damage or injury resulted from (incorrect) use of this device.
For more info concerning this product, please visit our website www.perel.eu.
The information in this manual is subject to change without prior notice.