Operation manual
16
cover (1) on the frame (3). At that the cross angle sections on the turnstile housing cover (1)
should be maximum close to relative plug-in guides in the frame (3). Adjust the turnstile housing
cover (1) by moving it from right to left against stop and after fix it by the turnstile housing cover
lock (9). The turnstile housing cover lock (9) is closed without key by pushing it.
14. To mount the barrier arms into the run position, remove the cover (17) from the hub (16)
unscrewing the screw (18). Unscrew the fixing bolt (19) on the barrier arm (6). Fit the barrier
arm into the mounting hole on the hub (16) and fasten it with the bolt (19). Put a spring washer
under the bolt head. The bolts must be tightened so as to provide reliable fixation of the barrier
arms without a gap.
15. Repeat the above-described procedure for fitting up the remaining barrier arms.
16. Put the cover (17) onto the hub (16) and fix it with the screw (18).
Fig. 11. Cables layout inside the turnstile housing
1 – power supply cable, 2 – RC panel
/ WRC /
ACS controller cable, 3 – turnstile cable,
4 – indication cable, 5 – CLB, 6 – control mechanism, 7 – intrusion detector, 8 – siren;
А4, А6
–
А9, А11
– see Fig. 4.
