PERCo RTC-15, Assembly And Operation Manual Warranty Card

Page: 13 / 22

Assembly and Operation Manual
8.3.11 Choose direction of the water drainage off the canopy and visually determine pitch
of the drains (11). Lift and place the roof assembly on the posts in such way as to achieve
the chosen drainage direction.
8.3.12 Drive the screws
М 6×30 with washers into the thread bushings in the roof sections
through the four holes in the top flange (5) (Fig. 7). Obtrusive ends of the thread bushings
should enter the counterbored holes in the top flanges. Differences between diameters of
the bushings and the holes, and the screw M6 and the flange hole allow compensating for
possible installation faults.
Figure. 7 Fixing the roof assembly to the post (3)
8.3.13 Use the fasteners and fix both sides of the canopy through the jointing flanges to
adjacent equipment:
8.3.13.1 when the canopy is used together with a standalone turnstile without railings,
fix it to the turnstile top channel by two «Turnstile-Canopy» brackets mounted on both
ends of the top channel (Fig. 8.3.16);
8.3.13.2 when two or more turnstiles are used together with canopies joined in a row,
or when turnstiles are used together with canopies and railings installed at one or both
frontal sides, follow instructions given in corresponding installation documents.
Do not
:
use the canopy that is not fixed to the turnstile or railings with brackets. Both frontal
sides of the canopy should be fixed to adjacent equipment.
8.3.14 Install the
«
Turnstile-Canopy» bracket as follows:
8.3.14.1 Take off the top channel cover (refer to the RTD-15 Operation Manual);
8.3.14.2 Unscrew two bottom screws
М 6×40 with nuts and washers (Fig. 8) from the
canopy jointing flanges on the side of the turnstile barrier section (Fig. 5);
12