30
31
06. Cleaning and Care
DANGER!
Remove the wall power supply from the power point
before cleaning the shaver.
Never submerge the entire shaver in water.
Dry Cleaning
WARNING!
• Always switch off the shaver before cleaning it.
• Do not use any harsh or abrasive cleaning agents.
• Do not remove the shaving foil from the shaving foil frame (see
fig.
➌
) and do not clean it with the brush.
• Do not pull the 2 cutting blades off the white holder (see fig.
➍
).
NOTE:
Clean the shaver after every use to warranty optimal results.
• For thorough cleaning, remove the shaver head (
2
) from the
shaver by simultaneously pressing both unlocking buttons (
4
).
• Knock the blade head on a flat surface and blow it out.
• Clean the cutting blades with the cleaning brush.
➌
➍
Cleaning with Water
• The cutting blades (
3
) are easily removed by pulling up and can
then be cleaned separately.
Make sure the cutting blades securely snap back into place when
reattaching the blades.
The removed shaving and cutting parts of your shaver are easily
cleaned under running water. The water temperature should not be
above 70 °C.
DANGER of electric shock!
Before removing and cleaning the shaving and cutting parts
under running water,
the power cord must be detached
from the shaver.
• You may also apply a few drops of commonly used liquid soap to
clean these parts under running water.
CAUTION!
The housing may be cleaned wet; however, the shaver must
not be submerged in water!
• Let all parts dry thoroughly before putting them back onto the
shaver.
Touch the sides of the shaver head (
2
) only. Press it down until the
locking brackets click into position.
CAUTION:
Do not use excessive force and do not press on the shaving
foil!
NOTE:
We recommend you occasionally apply a few drops of sewing
machine oil to the long hair trimmer and the cutting blade.
