76180 EM -42/73-
t. MWB
Manual Balance
Change
MF
MANUAL
02
u. CFDOOR
CF door
Change
AFC
AF continuous
00
AFS
AF
single
01
z. TVDIAL
Tv dial
－←
0
→＋
1. AVDIAL
Av dial
－←
0
→＋
ACDET
GRIP
MAIN
N/A
22-5. [CONF] AF
・
SI (Superimpose) Function
①
Attach the lens to the camera and set the focus mode lever to AF.S.
②
The distance ring of the lens must turn between infinity (
∞
) and shortest distance end when
the shutter button is depressed halfway while covering the front of lens with the palm.
③
Set the focus mode lever to SEL. Confirm that the red LED of SI (Superimpose) in the
viewfinder must light by the four-way controller.
22-6. [CONF] Shooting
・
Playback Function
[CAUTION] Never install or remove the CF card while turning the camera’s power ON as this
may cause the CF card or camera to be damaged and become unusable.
①
Turn the main SW to OFF and insert the CF card (for Taking picture) into the camera.
②
Connect the video cable to the camera.
③
Turn the main SW to ON and then press the MENU button to display the menu screen on
the TV monitor.
④
Format the CF card as the four-way controller according to the instruction on the menu
screen. Confirm the CF card has been formatted correctly.
⑤
Set the Quality level and Recorded pixels to the default setting and take three pictures.
(Quality Level: Best, Recorded Pixels: L)
⑥
Press the Playback button and confirm the image quality of them by the video monitor.
⑦
When the INFO button is pressed during playback, the camera must switch from Normal
Playback Screen to Histogram Display.
⑧
When the INFO button is pressed again, the camera must switch from Histogram Display
to Detailed Information display.
⑨
Press the Delete button, and then delete all images by the AV dial and four-way controller.
⑩
Turn the main SW to OFF and remove the CF card from the camera.
⑪
Disconnect the video cable from the camera.
22-7. [CONF] Flash Function
①
The built-in flash pops up when the flash button is pressed. And, must be appeared in
the viewfinder and on the LCD panel when flash is fully charged.
②
The flash must be discharged when taking a picture in low light condition.
③
The built-in flash must be retracted firmly when flush is pushed down by finger.
④
Confirm that must be appeared and discharged when an external flash is attached.
22-8. [CONF] Aperture Control
・
CCD
①
Attaching the lens to the camera. Set the focus mode and Capture mode to MF and B.
