76180 EM -32/73-
11-2. Function Check
[Caution] Do not touch the shutter blades while checking the function.
11-2-1. Power
・
Main SW
①
Connect the DC cord to the DC power supply and set the voltage to DC6.5V (3A).
②
Turn the main SW to OFF and connect the DC cord to the camera. At this time, there must
be neither short nor Leakage. (Main SW/OFF: *Ave. 10mA)
③
Turn the main switch to ON and LCD must be displayed five seconds later. At that time,
current consumption must be within the standard below.
(Main SW/ON: Light metering OFF: Ave. 240mA*, Light metering ON: Ave. 420mA*)
④
When the main SW is turned to , the diaphragm actuate lever (0-G100) must be done
vertical motion. And, the LCD display must be illuminated.
* When the power is supplied by the DC input terminal.
11-3. Exposure
・
Release
①
Attach a lens to the camera and set the AF_SW to MF position (up position).
②
Set the mode dial to Green Program AE Mode.
③
The information of Tv and Av must be displayed in the viewfinder and on the LCD panel
when the release button is depressed halfway.
④
The information of Tv and Av must be changed when the mode dial is set to the each
exposure mode.
⑤
The bar graph must be displayed in the viewfinder when the mode dial is set to M.
⑥
The setting of multiple exposure and AEB must become possible when depressing the
multiple exposure/AEB button.
⑦
Set the mode dial to B (Bulb).
⑧
The aperture of lens must change similarly when the aperture value (Av) is set in opening,
the middle, and the minimum with the Av dial. The shutter must open at the same time,
too.
⑨
The camera must be released by the cable switch.
⑩
The camera must be released by a remote controller when the drive mode is set to the
remote control mode. The PCV signal must sound at the same time, too.
11-4. Mode dial
①
Set the mode dial to ISO.
②
The ISO sensitivity must change from 200 to 1600 (3200) when the Tv dial is turned.
③
Set the mode dial to .
④
The quality level must change as follows when the Tv dial is turned.
(RAW
⇔
TIFF
⇔★★★⇔★★⇔★⇔
)
⑤
The recorded pixels must change as follows when the Av dial is turned at the position other
than RAW position. (L
⇔
M
⇔
S
⇔
)
⑥
Set the mode dial to WB.
⑦
The setting of White Balance must change when the Av dial is turned.
⑧
Initialize the setting of ISO, and WB by pushing the green button while setting the
mode dial to each position.
