EASYLOGO 2-00 E
B 55002.11-2022.01
Responsibility of the operating company
Installation and operation of the product must be carried out according to current technical codes of practice.
Note!
In EU countries and the countries of destination, the standards, regulations, rules and directives that apply in that country
must be implemented.
Like any other electrical device, this product can fail due to the absence of mains power or due to a technical fault. If damage or conse-
quential damage occur due to failure of the device, take the following precautions at your discretion:
∙
Installation of a water level-dependent alarm, that is either dependent or independent of the mains power supply, so that the “high
water” alarm can be perceived before damage occurs.
∙
Check the collecting tank/chamber used to ensure it is leak-tight up to the upper edge before putting the product into operation.
∙
Installation of backflow protection devices for drainage objects where damage can occur due to wastewater leakage after product
failure.
∙
Installation of an additional product that can compensate for the failure of the product.
∙
Installation of an emergency power generator.
Unauthorised alterations, spare parts and accessories
∙
Alterations or modifications to the product are permissible only with the written approval of the manufacturer.
∙
Use only the manufacturer’s original spare parts and accessories.
∙
Unauthorised alterations and the use of non-original spare parts and accessories may result in a loss of warranty and liability for the
products and for any consequential damage.
General safety
Note!
In EU countries and the countries of destination, the standards, regulations, rules, and directives on accident prevention
that apply in that country must be implemented.
ATTENTION!
∙
The instructions and warnings in this manual must be complied with!
∙
Wear personal protective equipment.
∙
Hazardous pumped fluids must be discharged in such a way that there is no danger to persons or the environment!
∙
Components and products that have come into contact with hazardous pumped fluids must be decontaminated.
∙
All safety and protective equipment must be re-installed and re-activated immediately after work has been completed.
Next, check that all functions are working properly.
ENGLISH
11
