Pentair Goyen Precision Deine-007, Installation And Operating Instructions Manual

Page: 18 / 28

18 INSTALLATION AND OPERATING INSTRUCTIONS PRECISION
®
FILTER CLEANING SYSTEM CONTROLS
MESSAGES
Scrolling.Display
DISPLAY DESCRIPTION
Model xx.xx Software version number
Continuous Mode P2 Controller is in Continuous Mode
Demand Mode P2 Controller is in Demand Mode
On Time = xxx ms Electrical On Time of Solenoid
Off Time = xxx sec Electrical Off Time of Solenoid
Slaves
=
xxxx Number of Slaves connected to Controller
Blowdown cycles = xxxx Number of complete cleaning cycles the controller performs after the fan has been switched off
Remote Stop
=
Hardwired P2 Remote Stop is hardwired to the fan or circuit breaker
Remote Stop = Automatic P2 Remote Stop is dependent on dP of system
Hour Counter = xxHrs Number of hours the controller has been operational
Total Cycles
=
xxxxxx Number of complete cleaning cycles the controller has performed
Max. Interval = xxx P2 The maximum time that can elapse before a cleaning operation takes place (only in use when in
Demand Mode)
Pattern Cleaning
=
xxx P2 Allows the controller to ‘Off’, ‘Skip 1’ or ‘Skip 2’ outputs (refer to cleaning patterns)
Alarm Delay = xxx sec P2 Delays high dP and Auxiliary Alarm for this amount of time to avoid false alarms due to system spikes,
etc.
Tube Cleaner = xxxx ‘Off’, ‘Tube Cleaner Duration’ and ‘Tube Cleaner Period’
Units
=
xxx P2 Current units being used for display of dP
P2 Only for the P2 interface.
General.Messages
DISPLAY DESCRIPTION
dP = xxxx (units) P2 Current dP
Stopped (dP) P2 Remote Stop due to Automatic Blowdown dP measurement
Stopped (Fan) Remote Stop due to Hardwired Blowdown
Manual Cycle P2 Either the Manual Cycle button or contact (P-CTX) has been activated. The controller is now performing
one complete cleaning cycle with the programmed On and Off Time.
Cycling – Paused P2 Controller waiting for dP to exceed High dP Limit value
Cycling –(Precoating) P2 Controller waiting for dP to exceed Precoating value
xxx sec Countdown to next solenoid operation
xx:xx Next SLAVE# : OUTPUT# to operate
Tube Cleaner xx sec Controller is performing a Tube Clean operation with xx sec remaining
P2 Only for the P2 interface.
MESSAGES AND ALARMS