User Guide Fleck 2910-NXT
6 / 36
Ref. MKT-UG-002 / B - 26.06.2018
3.3.
Components description and location
3.4.
Bypassing
If the system is equipped with a bypass and if a problem occurs, turn the valves to bypass the system as shown in the picture
below.
4 .
Programming
Note:
The controller must be plugged in to be programmed.
After 5 minutes with no button pressed, the unit returns to normal operation without saving.
4.1.
Basic programming
Note:
Menus are displayed in a defined and incremental order.
Choice of language
Feed water hardness
Note:
This parameter is not visible in Timeclock mode, and allows to adjust the water hardness in °tH.
Calendar override
Note:
Determine the maximum number of days of operation without regeneration.
A
Press
and
simultaneously for 5 seconds to enter the menus sequence.
B
Select the language to be displayed with
and
.
C
Press
to validate the selection and advance to the next parameter.
SELECT LANGUAGE:
ENGLISH
D
Adjust the hardness with
and
.
E
Press
to validate the selection and advance to the next parameter.
WATER HARDNESS
DEGREE 0030fTH
F
Adjust the number of days with
and
.
G
Press
to validate the selection and advance to the next parameter.
CALENDAR
OVERRIDE 03 DAYS
Shift button
UP/DOWN button
LCD display
Regen button
Outlet
ON/OFF Line Indicator
Meter
Injector
Drain
Meter connection
Diagnostic button
Inlet
Status LED
In Bypass
In
In
Out
Out
Softening
System
Softening
System
Normal
operation
Fleck_2910-NXT_UG_VV_Multilingual.book Page 6 Mardi, 26. juin 2018 4:01 16
