background image

troubleShootIng guIde

Problem

Possible cause

remedy

Insufficient product water 

1. 

during normal operating 

periods.

a. Pre-filter cartridge plugged.

Replace pre-filter cartridge.

a. 

TO cartridge plugged.

b. 

Replace TO cartridge.

b. 

RO cartridge plugged.

c. 

Replace RO cartridge.

c. 

Insufficient system inlet pressure.

d. 

Check/repair booster pump and inlet line.

d. 

e. Incorrect storage tank pre-charge.

e. Empty water in storage tank. Check pre-charge 

pressure. Adjust to 5-10 psi (typical). Presence 

of water at Schrader valve indicates failed 

bladder - Replace bladder or tank.

Insufficient product water 

2. 

volume during peak periods.

Refer to problem 1.

a. 

Refer to problem 1.

a. 

System rated output low for application.

b. 

Verify system output. If output is within 

b. 

specification, increase output if applicable.

System storage capacity low.

c. 

Increase storage capacity if applicable.

c. 

Low quality RO water.

3. 

Refer to problem 1.

a. 

Refer to problem 1.

a. 

RO cartridge failure.

b. 

Replace RO cartridge.

b. 

Low water pressure at water 

4. 

using equipment.

Tubing/piping run to equipment restrictive.

a. 

Increase tubing/piping diameter. Refer 

a. 

to "System Installation" section for 

recommendations.

Incorrect storage tank pre-charge.

b. 

Empty water in storage tank. Check pre-charge 

b. 

pressure. Adjust to 5-10 psi (typical). Presence 

of water at Schrader valve indicates failed 

bladder - Replace bladder or tank.

Objectionable product water 

5. 

odor.

TO cartridge exhausted.

a. 

Replace TO cartridge.

a. 

Storage Tank requires disinfection.

b. 

Disinfect storage tank.

b. 

Wastewater flow too low or 

6. 

decreases over time.

Drain line restricted.

a. 

Check/correct any restrictions in drain line 

a. 

tubing. Make sure to allow an air gap at the 

drain. Disconnect reject line at quick connect 

fitting and inspect for obstruction or damage. 

Remove obstruction. Replace if required.

Insufficient system inlet pressure.

b. 

Check/repair booster pump and inlet line.

b. 

7

rePlaceMent cartrIdgeS  (See next page for diagram)

key Part no.

deScrIPtIon

N/A

EV9109-08

P5 Pre-Filter (not pictured here)

26

EV9607-41
EV9627-04

6TO-BW Cartridge
7TO-BW Cartridge

27

EV9627-11
EV9627-03
EV9627-07

MR-100 Cartridge
MR-255 Cartridge
MR-350 Cartridge

key Part no.

deScrIPtIon

28

EV9627-05
EV9668-24

7CC-BW Cartridge
BW 4400

3123-42b IO Guide MRS - 112108.indd   7

9/11/09   11:15:30 AM

Summary of Contents for EV9970-20










Reviews: